Disabling Directory Browsing / File listing in Jboss

By default directory browsing /file listing is in 'enable' state in Jboss configuration.

Problem: If at all the directory browsing is enable, the user who is browsing your website can see the files list in the subfolders and able to access the files which ever he can see in the page.

To disable Directory browsing / file listing go through the modifications mentioned below

Files to Modify: web.xml
Location of File: Locate it in ..../deploy/jbossweb-tomcatXXX.sar/conf/
(*Note - Tomcat version may change depeding on the version of Jboss)

Modifications:
Before -
listings
true

After -
listings
false

Lets Rock

Cisco ATA 186 How To

Requirements:

1. Cisco ATA 186 Adapter with power connector
2. Analog telephone with a telephone cable (RJ-11)
3. Ethernet - Local Area Network connection (RJ-45)

Getting Ready:

1. Connect the Ethernet cable to the ATA.
2. Connect the telephone cable to the phone line 1 port in the ATA, which is connected to Analog telephone at the other end.
3. Plug-in the power cable and switch-on the power.

Using IVR of ATA:

1. Lift the telephone hand set.
2. Then, press the function key of the ATA (which is glowing)
3. Now, you can hear a voice in the telephone. That is nothing but the configuration mode. (IVR)
4. Follow and provide required response codes to modify/review different configurations.
5. Press ‘#’ button, when IVR asks on the telephone to exit from the menus/submenus.

Configuration:

1. Press the response code followed by ‘#’. See Example-1.
2. Then the IVR once reviews the entry and asks for confirmation. See Example-2.
3. After configuring press ‘#’ to quit the menu.

Tips & Tricks:

1. When entering IP addresses and subnet mask for ATA use ‘*’ to enter ‘.’(dot). See Example-3.
2. If you stuck anywhere in the middle of the configuration, just quit by pressing ‘#’ and hang-up the phone and start from the beginning.
3. For more information for response codes, refer “cisco_ata_186_voice_menu.doc” document.

Examples:

1. Response codes - IP address change (1#), Subnet mask change (10#), Network route change (2#)
2. Confirmation codes – Modify(1), Review(2), Save(3), Review and Save(4) and to exit(#)
3. IP Address - 192*168*1*100, Subnet mask – 255*255*255*0
   

Lets Rock